Pcmate platinum software install#
Pcmate platinum software drivers#
Pcmate platinum software windows#

I have the EVGA X97 Classified and its not a memory issue. My bios is on version 2.06, and I'm up for any suggestions, I am currently not overclocking my i7 nor am I pushing my RAM, The memory settings are using the XMP1 profile, but I'm basically just running it as is.ДЄny thoughts anyone, thanks ahead of time.

Pcmate platinum software install#

Is there something I'm missing that's keeping me from doing this update, or is the update the issue and I need to just block it until something else comes along and end up doing a fresh install from that ISO? So my question for EVGA techs, and anyone else who might have one, is what to do now?

Pcmate platinum software drivers#

The system booted and installed and then I tried the update and I had the same behavior, this time when it rolled back there appeared to be issues left over, such as not being able to open device manager without being giving a message that the administrator was preventing me from opening it, when I'm a local account and the admin, it also was running high disk usage so I decided that that rollback had given me a problem and again I went installed 20 H1, again wiping the partitions of my boot drive and reinstalling, that installation went fine, and I have no issues with the OS at this point, I actually started to replace files back to my desktop and documents etc and started to do some replacements of drivers such as the chipset, my graphic card, you know what I mean. Today I installed the May update, 2004, 20H1, and I had also decided to take the time to switch my BIOS from legacy to UEFI boot, and basically switched my lineup for my boot drive to the newer mode instead of MBR since I was reinstalling the OS, my two other drives are MBR and that is no issue because they're secondary. When the system is on the previous version I have no problems whatsoever and I have never had blue screens before now when trying to do this update.

Pcmate platinum software windows#

On my current RAM meme test 86 ran overnight and no issues, Windows memory diagnostic app ran an extended mode with cache and found no issues. I had swapped my ram sticks, I even tried an old set of ram sticks that had never given me any issues before, and I had the same behavior. This installed with no issues, until I got to the desktop, after which in a couple moments, enough time for me to try and open settings, and then it would blue screen with page fault. I wiped and then tried to install 20H2 from USB that was created with the media creation tool. The log showed that I put on 10 forums that it was something to do with Intel management engine, but I also uninstalled that and retried, same thing.ДЄt some point I must have uninstalled something and then I couldn't boot to the drive at all, and at that point I decided that I would wipe my boot drive, as a lot of my files are not on it I have two other drives for that. It would do the typical two-boot try and then do the automatic repair and uninstall the update and I would be back to my desktop. When it tries to do the monthly November incremental, and/or does the feature update to 20H2, the update begins and installs and after 30% when the computer restarts, it begins the reboot sequence and then I get a blue screen with a page fault error. Hello, I need some help with my Z97 board, I run it with Corsair 16 gig RAM kit which is to 8 gig sticks, and I've had no issues with it with my i7 until now.